Buying a home

Building inspector or structural engineer before you buy?

What a building inspection in Adelaide covers, when to add a structural engineer, and how to fit both inside South Australia's short cooling-off period.

Gloved hands holding a clipboard checklist and a torch at the front wall of a bluestone villa with red-brick quoins

In short

Before buying in Adelaide, most buyers book a pre-purchase building inspection: a visual check of the whole house to AS 4349.1. Add a structural engineer when the report flags cracks, footing movement, sloping floors, leaning retaining walls or removed walls. South Australia's cooling-off period lasts only two clear business days, and there is none at auction, so line up the engineer before you sign.

Key takeaways

  • A building inspector checks the whole house for defects. A structural engineer finds the cause and seriousness of a structural problem.
  • SA's cooling-off period ends two clear business days after you receive the vendor's statement (Form 1). There is no cooling-off at auction.
  • If the inspector writes "refer to a structural engineer", book the engineer before your deadline, not after it.
  • Our pre-purchase structural inspection starts from $990 + GST ($1,089 inc GST), with a fixed quote in under 20 minutes on average, during business hours.

"Building inspection Adelaide" is one of the most searched property phrases in South Australia. A building inspector and a structural engineer do different jobs, though, and knowing which one you need, and in what order, matters more here than in most states because the cooling-off period is so short.

Inspector or engineer: quick facts

Building inspector
Visual whole-of-house check to AS 4349.1
Structural engineer
Cause, severity and repair scope of structural issues
Cooling-off in SA
2 clear business days; none at auction
Our pre-purchase inspection
From $990 + GST ($1,089 inc GST)
Cracking in SA
6.5% of houses have major ceiling or floor cracks
Our quote
Fixed, in under 20 minutes on average, during business hours

What is the difference between a building inspector and a structural engineer?

A building inspector looks at the whole house for defects; a structural engineer looks at whether the structure is sound, why it is moving and what it would take to fix. The inspection is broad and visual. The engineer's assessment is narrower and deeper, and it can lead to a repair design and a certificate later.

 Building inspectorStructural engineer
Main questionWhat defects does this house have?Is the structure sound, and why is it moving?
ScopeRoof, walls, wet areas, subfloor, site drainage, safety itemsFootings, slabs, walls, framing over openings, cracks, retaining walls
BasisAS 4349.1, visual, accessible areasEngineering assessment; cracks rated against AS 2870
ReportDefect list with photos; refers specialist items onCause, severity, likely repair scope and urgency
Timber pestsOften combined as a building and pest inspectionNot covered
Can design a repair?NoYes, with drawings and calculations for your certifier

Inspectors and engineers each work to their own scope. Ask any inspector what qualifications they hold and whether the report follows AS 4349.1.

How much does a building inspection cost in Adelaide?

A building inspection in Adelaide typically costs a few hundred dollars, and an engineer's pre-purchase structural inspection costs more because it goes deeper on the structure. Prices vary with the size and age of the house, so treat the ranges below as a guide.

ServiceWhat the figure coversPrice
Building inspectionSA quote marketplace range, GST not statedAbout $400–$600
Building and pest inspectionSA quote marketplace range, GST not statedAbout $500–$750
Desktop review of the building report and photosOur engineer reads the report and tells you whether a visit is neededFrom $350 + GST ($385 inc GST)
Site inspection with a letter of adviceOne specific question, such as a single crack or a removed wallFrom $550 + GST ($605 inc GST)
Pre-purchase structural inspectionOur engineer's site inspection and full reportFrom $990 + GST ($1,089 inc GST)

A sloping block, a long subfloor or several structures (a house plus a granny flat and high retaining walls, for example) take longer to inspect, and your fixed quote reflects that before anything is booked. See all our prices.

How long is the cooling-off period when buying in SA?

South Australia's cooling-off period ends at the close of the second clear business day after the vendor's statement (the Form 1) is served on you. Weekends, public holidays and the day of service don't count.

  • No cooling-off at auction. Inspections have to happen before auction day.
  • It can be waived, often when an offer is made before auction, but only with a certificate from a solicitor. Waiving it means no inspection window and no change of mind.
  • To cool off, you serve written notice that you don't wish to be bound by the contract. No reason is needed, and any deposit over $100 must be refunded.

Two business days goes quickly

Two clear business days is tight for a building inspection and an engineer. If you can, inspect before you sign, or ask your conveyancer or solicitor about a building inspection condition with enough time to add an engineer. This is general information, not legal advice.

When should you add a structural engineer before you buy?

Add an engineer whenever the building inspector refers a structural item on, or when the house or block shows signs of movement. This flow covers the common triggers.

  1. Has the building inspector recommended a structural engineer?

    Many reports refer cracking, footing or framing issues to a specialist.

    Yes: book an engineer before your deadlineNo: keep going
  2. Are there cracks 5 mm or wider, stepped cracks, sloping floors or sticking doors?

    A crack of 5 mm or more is moderate damage on the AS 2870 scale.

    Yes: get the cause foundNo: keep going
  3. Is it a sloping block, or held up by retaining walls over 1 m?

    A wall retaining more than 1 m is development in SA and should have been approved.

    Yes: have the walls checked. See retaining wall rulesNo: keep going
  4. Have walls been removed, or an extension, deck or granny flat added?

    Removing a load-bearing wall needs approval. Ask the vendor for approvals and certificates.

    Yes: have the structure checkedNo: the building inspection is usually enough
  1. Cat 0Negligible< 0.1 mm
  2. Cat 1Very slight< 1 mm
  3. Cat 2Slight< 5 mm
  4. Cat 3Moderate5–15 mm
  5. Cat 4Severe15–25 mm
  6. Cat 5Very severe> 25 mm
Figure 1Damage categories for walls, with approximate crack widths. Crack width is a guide only: the number, pattern and location of cracks also matter.Source: AS 2870-2011 Residential slabs and footings, Appendix C, Table C1.

What does an engineer look for in an Adelaide house?

An engineer looks for the cause behind the cracks, and in Adelaide that is usually the ground or the age of the building. South Australia has the highest share of houses with major ceiling or floor cracks of any state or territory, at 6.5% in ABS data for 2019–20.

  • Reactive clay. Much of Adelaide sits on highly reactive clay; every site needs its own classification. Stair-step cracks in brickwork often follow the seasons. See reactive clay soils.
  • Stone villas and cottages. Bluestone and sandstone walls with lime mortar move and decay differently from brick veneer. See looking after a bluestone home.
  • Salt damp. Decay at the base of old walls is common in Adelaide; the question for the engineer is whether it has affected stability. See salt damp or structural cracking.
  • Trees and drainage. Large trees close to the house and leaking pipes dry out or wet the clay. See trees and house cracks.
  • Older pools. A pool built before 1 July 1993 must meet the safety standard MBS 004 before settlement, so ask the vendor about it.
  • Heritage overlays. In a Historic Area, demolition is restricted, which matters if you were planning a knock-down. Check the property on PlanSA before you buy.

What does a pre-purchase structural inspection include?

Our pre-purchase structural inspection is a site visit by an engineer and a report on the structure. It focuses on the items that change what a house is worth or what it will cost you after settlement.

  • Cracks measured, photographed and rated against the AS 2870 damage categories
  • Footings, slab edges and subfloor where they can be reached
  • Floor levels, door and window distortion, and framing over openings
  • Retaining walls, slope, site drainage and trees near the house
  • The likely cause, how serious it is, whether a repair is needed and its likely scope
  • Work that looks unapproved, such as a removed wall, so your conveyancer can ask the vendor for paperwork
Printed engineer's report with photo pages, a crack-width gauge card, glasses and a red pen beside a laptop showing a floor plan
Figure 2Each report explains the cause, the seriousness and the likely repair scope in plain English, with photos and measured crack widths.

We are engineering only. We don't sell or carry out repairs and we don't recommend contractors, so the report is about the house, not a job. If a repair is needed after you buy, we can design it for any builder to price, or give you an independent second opinion on a contractor's quote.

When should you call a structural engineer before buying?

  • The building report says "refer to a structural engineer" or "further investigation"
  • Cracks are 5 mm or wider, stepped through brickwork or wider at one end. See cracks in walls
  • Floors slope or doors stick, which can point to footing movement
  • Retaining walls lean or bulge, or the house sits on a steep block, as in parts of the Adelaide Hills
  • It's an old stone villa in an area like Norwood or Unley, with cracks or salt damp at the base of the walls
  • Your deadline is close: tell us the cooling-off, auction or settlement date when you ask for a quote

Send the building report with your request

Upload the inspector's report, a few photos and your deadline. Your fixed quote, in under 20 minutes on average, during business hours, says what's included and when the report will be ready. Get a fixed quote or call 08 7083 9853.

Sources

  1. Legal Services Commission of South Australia, Law Handbook: Cooling off period. Two clear business days after the Form 1 is served; no cooling-off at auction; waiver needs a solicitor's certificate
  2. City of Salisbury, Swimming pools. Pools built before 1 July 1993 must meet MBS 004 before settlement on sale
  3. InDaily, Cracking up: SA's nation-leading house faults (ABS data for 2019–20). 6.5% of SA houses have major cracks in ceilings or floors
  4. Published price ranges from a South Australian quote marketplace. Building and building and pest inspections, checked November 2026; GST and inclusions vary
  5. Standards Australia, AS 4349.1 Inspection of buildings, Part 1: Pre-purchase inspections, residential buildings
  6. Standards Australia, AS 2870-2011 Residential slabs and footings. Appendix C, damage categories for walls

FAQ

Building inspections and engineers: FAQs

Still unsure? Call 08 7083 9853 or send photos for a fixed quote.

Do I need a building inspector or a structural engineer before buying in Adelaide?

Most buyers need a building inspector first, for a whole-of-house check. Add a structural engineer when the inspector recommends one, or when you can see wide or stepped cracks, sloping floors, leaning retaining walls or walls that have been removed.

How much does a building inspection cost in Adelaide?

One South Australian quote marketplace lists building inspections at about $400–$600 and building and pest inspections at about $500–$750, depending on the house. Our pre-purchase structural inspection by an engineer starts from $990 + GST ($1,089 inc GST).

How long is the cooling-off period in South Australia?

It ends at the close of the second clear business day after the vendor's statement (Form 1) is served on you. Weekends, public holidays and the day of service don't count, and there is no cooling-off at auction.

Is there a cooling-off period if I buy at auction?

No. There is no cooling-off period for a property bought at auction in South Australia, so any building inspection or engineer's check has to happen before auction day.

Does a building inspector check the structure?

A pre-purchase building inspection is a visual check of the accessible parts of the house for significant defects, which includes obvious structural signs. Where something needs closer investigation, the inspector refers it to a specialist such as a structural engineer.

Can a structural engineer replace the building and pest inspection?

Usually not. We don't report on wet areas, roof plumbing, electrical safety or timber pests, so book those with a building inspector and a pest inspector and use us for the structural questions they raise.