New flat-roof steel verandah on slim grey steel posts with concrete pad bases at the back of a red-brick house, with a paved area and lawn beneath

Homeowners · Builders · Suppliers

Verandah, pergola, carport and deck engineering

Some low decks and open pergolas are exempt in South Australia, but verandahs, most carports and many decks need approval and structural drawings. We size the posts, beams, tie-downs and footings, and certify structures already built.

  • From $490+ GST ($539 inc GST)
  • Under 20 minaverage time to a fixed quote
  • 500 mmdeck height limit for the exemption
Quote requestMon–Fri 8am–5pm

Get a fixed quote for your structure

Send a sketch or the supplier's drawings with the size, height and distance from the boundary, plus a photo of where it will go.

We reply with a fixed quote in under 20 minutes on average, during business hours.

Engineering only
Designs from $490 + GST
Quotes in under 20 min on average
NCC & Australian Standards

In short

In South Australia a deck is exempt only if it is no higher than 500 mm above ground and at least 900 mm from any boundary, and an open pergola only if it has no solid roof, is no higher than 4 m and stays behind the building line. Verandahs, most carports and other decks need approval and structural drawings. Our engineering starts from $490 + GST ($539 inc GST).

Fee
From $490 + GST ($539 inc GST)
Exempt decks
Up to 500 mm high and 900 mm or more from boundaries
You receive
Drawings and calculations, or an engineer's certificate

South Australian rules

When does a verandah, pergola, carport or deck need approval in SA?

A verandah, pergola, carport or deck needs approval in South Australia unless it meets every condition of its exemption in the Planning, Development and Infrastructure (General) Regulations. Low decks, open pergolas and very small outbuildings can qualify; most verandahs and carports don't.

StructureExempt (not development) only whenNeeds approval when
DeckNo point is higher than 500 mm above natural ground, and no part is within 900 mm of a boundaryHigher or closer to a boundary, or in a bushfire prone area, the Historic Area Overlay, the Coastal Areas Overlay, the Hills Face Zone or the Significant Landscape Protection Overlay
PergolaNo solid roof, open sides, no higher than 4 m and not in front of the building lineIt has a solid roof, is taller or sits in front of the building line, or the property is a local heritage place
VerandahNot covered by the pergola exemption, because a verandah has a solid roofGenerally always
Carport or shedA small outbuilding: up to 15 m², a roof span up to 3 m and up to 2.5 m highAnything larger, which rules out most carports
Any of these on a State Heritage PlaceNo exemptions applyAlways

PDI (General) Regulations 2017, Schedule 4 clause 4 and regulation 3C. Your council or certifier confirms what your structure needs. Our guide to building approvals in SA explains the consents.

Is my deck exempt?

  1. Is the property in a bushfire prone area, Historic Area, Coastal Areas Overlay, Hills Face Zone or Significant Landscape Protection Overlay?

    Check the property on SAPPA or ask your council.

    Yes: approval neededNo: go to 2
  2. Is any point more than 500 mm above natural ground?

    Measure at the highest point, not the average.

    Yes: approval and a designNo: go to 3
  3. Is any part within 900 mm of a boundary?

    Include steps and landings.

    Yes: approval and a designNo: usually exempt

Fewer forms for Class 10 structures

Most carports, verandahs and sheds are Class 10 buildings under the NCC. They need no certificate of occupancy, and no Statement of Compliance at completion unless the structure is a swimming pool or a private bushfire shelter. They still need approval where they aren't exempt.

Exempt doesn't mean unengineered. A low deck on Adelaide's reactive clay, or an open pergola fixed to the house fascia, can still move, sag or lift in a storm if its footings and fixings are wrong. If you're unsure, a site inspection or desktop review tells you before you build.

What we design

What does the engineering for an outdoor structure cover?

The engineering covers the whole load path, from the roof sheets or deck boards down to the ground: what holds the structure up, what stops wind lifting it, and what it stands on.

Footings

Pad footings, bored piers or screw piles, sized for the load, the uplift and your site class.

Posts and bracing

Steel or timber posts, their base plates and bracing, so tall or freestanding structures don't sway.

Beams, rafters and joists

Member sizes, spans and spacing, including cantilevered carports and wide openings without posts.

Fixing to the house

Connections into the house frame, rafters or slab, not just the gutter or fascia, or a freestanding frame where the house can't take the load.

Tie-down

Holding the roof down against wind uplift, from the sheets and purlins to the footings.

Balustrades and stairs

Posts and fixings strong enough for barrier loads where a deck is high enough to need one.

Kit structures

Kit verandahs and carports often come with standard engineering for set spans, heights and wind conditions. If your structure is wider, taller, attached differently or on a more exposed site than the tables allow, it needs a site-specific design. Send us the supplier's drawings and we'll tell you which.

Footings

Why do footings matter for verandahs and decks on reactive clay?

Footings matter because a verandah or deck sits on small pad footings while the house sits on a slab or strip footings, and on reactive clay the two can rise and fall by different amounts. Much of Adelaide sits on highly reactive clay, and every site needs its own classification.

Where a structure is fixed to the house at one side and stands on its own posts at the other, that difference in movement shows up as cracked pavers, a sagging gutter line or a deck that tilts. The design deals with it in three ways:

  • Footing depth and size chosen for your site class, using the house's existing site classification where there is one
  • Connections that allow movement where the structure meets the house, or a freestanding frame
  • Drainage that sends roof water away from both sets of footings, not into the clay beside them

Uplift matters as much as weight. In a storm the wind tries to lift a roof off its posts, and the footings have to hold it down, which is why a carport footing is often bigger than its weight alone would suggest. See site classification and footings and stormwater and drainage plans.

Fixed fee, agreed first

Verandah, pergola, carport or deck engineering

$490+ GST · $539 inc GST · starting price

A typical single structure at a house in Greater Adelaide. Large, freestanding, cantilevered or elevated structures are priced in your fixed quote. Design from drawings is available anywhere in South Australia.

  • Posts, beams and roof or deck framing sized
  • Footings for your site class and the wind uplift
  • Connections to the house detailed
  • Drawings and calculations for approval

Key takeaways

  • Decks up to 500 mm high and 900 mm from boundaries can be exempt, outside the listed overlays.
  • A solid roof takes a pergola out of its exemption.
  • Wind uplift often sizes the footings, not weight.
  • Already built? An engineer's certificate may be possible.
Stone cottage with a bullnose verandah and a weatherboard house with a return verandah on a winding road among tall gum trees, with mist in the Adelaide Hills valley behind
Figure 1In a bushfire prone area like much of the Adelaide Hills, even a low deck needs approval, and bushfire construction rules apply.

Hills, coast and heritage

What changes in the Adelaide Hills, on the coast and in Historic Areas?

In these places more structures need approval, because the deck exemption switches off and extra rules apply. Check your property's overlays before you plan.

  • Bushfire prone areas. The deck exemption doesn't apply. All land in the Adelaide Hills Council area must meet bushfire construction requirements; the bushfire attack level assessment comes through your designer or builder, and we design the structure to suit. See Adelaide Hills and Blackwood.
  • The coast. Decks in the Coastal Areas Overlay need approval. See Glenelg and Henley Beach.
  • Historic Areas and heritage places. Decks in the Historic Area Overlay need approval, pergolas on local heritage places aren't exempt, and nothing on a State Heritage Place is. See bluestone and heritage homes and Norwood.
  • Sewer easements. Carports and sheds over or near an SA Water main need SA Water's approval, with demountable construction over a main.

Already built

Can an existing deck, verandah or carport be certified?

Often it can. If a structure went up without approval, or a buyer or certifier wants evidence it's sound, we inspect it, check it against the standards and either certify it or design a fix first.

  1. Send photos

    The structure from below and above, its posts, footings, fixings to the house and any balustrade, through the form on this page.

  2. Inspect and check

    We inspect on site, sometimes exposing a footing, and check sizes, spans, connections and tie-down.

  3. Certify or design a fix

    An engineer's certificate, from $390 + GST ($429 inc GST), if it's adequate, or a repair design your builder carries out first.

Your council or certifier decides the approval path for a structure built without consent; we provide the engineering evidence they ask for. Building next to a slope? Decks and carports on sloping blocks often sit beside a retaining wall, and we can design both together.

FAQ

Verandah, pergola, carport and deck FAQs

Still unsure? Call 08 7083 9853 or send photos for a fixed quote.

Do I need council approval for a pergola in SA?

Not if it has no solid roof, open sides, is no higher than 4 m and isn't in front of the building line, and the property isn't a local or State heritage place. A pergola with a solid roof is outside that exemption and needs approval.

Does a deck need approval in Adelaide?

Not if no point is more than 500 mm above natural ground and no part is within 900 mm of a boundary. That exemption doesn't apply in a bushfire prone area, the Historic Area Overlay, the Coastal Areas Overlay, the Hills Face Zone or the Significant Landscape Protection Overlay.

Does a verandah or carport need an engineer?

Usually. Most need approval, and the building consent application needs structural drawings for the posts, beams, tie-downs and footings. Kit suppliers often provide standard engineering; where your span, height or site falls outside it, a site-specific design is needed.

How much does pergola or carport engineering cost in Adelaide?

Our verandah, pergola, carport and deck engineering starts from $490 + GST ($539 inc GST). Larger, freestanding or cantilevered structures cost more, and your fixed quote arrives in under 20 minutes on average, during business hours.

Can you certify a deck or verandah that's already built?

Often, yes. We inspect it, sometimes exposing a footing, check it against the standards and issue an engineer's certificate from $390 + GST ($429 inc GST) if it's adequate, or design a fix first if it isn't.

Can a carport be built over a sewer easement?

Only with SA Water's approval. Its encroachment rules say a carport over a main must be demountable with 2.4 m openings for access, with clearances of 1.0 m for demountable and 1.5 m for masonry structures. Check SA Water's current rules for your block.

Can solar panels go on my carport or verandah roof?

Yes, if the frame is designed for them. Panels add weight and change the wind load on the roof, so tell us about them before the design.

Do you build verandahs, pergolas or decks?

No. We are engineering only. Any builder or supplier can build from our drawings, and we never recommend one.