Base of an old bluestone wall with red-brick quoins, white salt efflorescence, crumbling mortar and flaking bricks beside a gravel path

Owners of older homes · Buyers

Salt damp and rising damp: the structural side

Adelaide is known for bad salt damp. Most of it is a job for a damp specialist, but some of it is structural: cracking with another cause behind it, wall bases so decayed that stability is affected, and high or thick walls that need temporary support while they are underset. That part is ours.

  • From $990+ GST ($1,089 inc GST), report included
  • Under 20 minaverage time to a fixed quote
  • Structural onlydamp-proof course work is the specialist's
Quote requestMon–Fri 8am–5pm

Get a fixed quote for a salt damp assessment

Photos of the wall base and any cracks, the house's approximate age and any damp contractor's quote help us price it.

We reply with a fixed quote in under 20 minutes on average, during business hours.

Engineering only
Assessments from $990 + GST
Quotes in under 20 min on average
NCC & Australian Standards

In short

A salt damp structural assessment is an engineer's check of what rising damp and salt attack have done to the structure of a wall. In Adelaide it starts from $990 + GST ($1,089 inc GST). Damp-proof course work and treatment are a damp specialist's job; we cover structural cracking, masonry so decayed that stability is affected, and temporary support during undersetting, which is not underpinning.

Fee
From $990 + GST ($1,089 inc GST)
We assess
Cracking, decayed masonry and support for undersetting
Independent
We never sell or carry out salt damp treatment

When it's structural

When does salt damp become a structural problem?

Salt damp becomes a structural problem when it has eaten far enough into a wall that the wall can no longer carry its load safely, or when the cracks you can see have a different cause, such as footing movement. Until then, it is a damp problem.

"Salt damp" is the term South Australians use for rising damp with salt attack. Adelaide is known for it, because hot, drying summers and salty soils draw salts up into the base of walls, where they crystallise and break down mortar, brick and soft stone. The damage typically sits about 0.5 to 1.2 m above the ground.

  • Deep decay: mortar washed out well behind the face, stones or bricks loose, or the wall base sounding hollow.
  • Bulging or leaning: a wall face moving out, often where the two faces of a thick stone wall have lost their bond.
  • Cracks above the damp zone: stepped or diagonal cracks running up the wall usually mean movement, not damp.
  • Openings: decayed brick or stone under a window sill or beside a door that is losing support.
Rough-faced sandstone wall with red-brick quoins around a timber sash window, weathered mortar and a hairline crack running from the sill
Figure 1Weathered joints are a damp problem. A crack running up from the sill is a different question, and it is the one an engineer answers.

Who does what

Damp specialist or structural engineer: who do you need?

You need a damp specialist for the moisture and a structural engineer only for what the moisture has done to the structure. Most salt damp jobs never need an engineer; the table shows where the line sits.

WorkWho does itOur part
Finding the moisture source, damp-proof course checksDamp specialistNone
Damp-proof injection or a chemical damp-proof courseDamp specialistNone
Lime repointing and sacrificial renderDamp specialist or stonemasonNone, unless the wall is unstable
Undersetting a low, sound wallDamp specialistUsually none
Undersetting a high wall or a thick rubble wallDamp specialist, with temporary supportTemporary support design and the order of work
Masonry so decayed that stability is affectedBuilder or stonemason, to a designAssessment and repair design
Cracks running up the wall, or doors and windows bindingEngineer first, then the right tradeFind the cause: movement or damp

The City of Adelaide publishes heritage specifications for damp-proof injection, salt damp management and undersetting: City of Adelaide heritage resources. We never sell, recommend a contractor for or carry out damp work.

Telling them apart

Is it salt damp or structural cracking?

Salt damp damage is low on the wall and spreads along it: white salts, powdery mortar, flaking brick faces and blistered paint inside. Structural cracking runs up through the wall, steps through the joints or opens from the corners of windows and doors, and it often comes with doors that bind or floors that slope.

Older homes often have both, so we look at the wall as a whole: how deep the decay goes, whether the cracks are moving, and what the footing is doing. Our guide to salt damp or a structural problem covers the signs in more detail, and a crack and footing movement report covers the movement side.

  1. Is the damage only low on the wall?

    Salts, fretting mortar and flaking faces up to about 1.2 m.

    Yes: go to 2No: go to 3
  2. Is the masonry still sound behind the face?

    Firm joints and stones that don't move when pressed.

    Yes: a damp specialist's jobNo: structural assessment
  3. Are there cracks running up the wall?

    Stepped, diagonal or wider at the top.

    Yes: crack reportNo: go to 4
  4. Is undersetting planned on a high or thick wall?

    Sections of the wall base will be cut out and replaced.

    Yes: temporary support designNo: no engineer needed yet

Undersetting

Undersetting is not underpinning: what's the difference?

Undersetting replaces the base of a wall, in short sections, with new masonry and a new damp-proof course, to stop moisture rising. Underpinning deepens or strengthens the footing under a wall after structural movement. One treats damp, the other treats a footing, and a damp quote that calls itself underpinning deserves a question.

Damp

Undersetting

Done by a damp specialist. Short sections of the wall base are cut out and rebuilt, so the wall above is carried by the masonry either side while each section is replaced.

  • Treats rising damp and salt attack
  • Works on the wall, above the footing
  • High walls and thick rubble walls may need temporary support designed by an engineer

Structure

Underpinning

Designed by an engineer and built by a builder. Concrete or piers carry the footing down to firmer ground, after the cause of movement is confirmed.

Digging beside a footing on reactive clay

Air drains and trenches dug along a wall to dry it out change the moisture in the clay under the footing. Guidance written for SA heritage bodies warns against air drains in reactive clay without geotechnical engineering advice. Ask before anyone digs.

How it works

What does a salt damp structural assessment include?

A salt damp structural assessment includes a site inspection of the affected walls, and a report on their condition, the cause of any cracking and what structural work, if any, is needed.

  1. Step 1

    Send photos

    The wall base, any cracks, the house's age and any damp contractor's quote or report.

  2. Under 20 min on average

    Fixed quote

    During business hours (Mon–Fri 8:00am–5:00pm), with the inspection date and report date.

  3. On site

    Inspect the walls

    Depth of decay, bond between the wall faces, cracks measured and rated against AS 2870, and the footing where it can be seen.

  4. On the date in your quote

    Your report

    What is damp work, what is structural, and the temporary support needed for undersetting, if any.

Salt damp structural assessment

A fixed fee, agreed before we start

$990+ GST · $1,089 inc GST · starting price

For bluestone, sandstone and brick homes across Greater Adelaide, including Norwood, Unley, North Adelaide, Port Adelaide and Woodville.

Own a bluestone or sandstone villa?

Salt damp is one of several problems old stone homes share. See bluestone and heritage homes and our guide to looking after a bluestone home.

FAQ

Salt damp and rising damp FAQs

Still unsure? Call 08 7083 9853 or send photos for a fixed quote.

Is salt damp a structural problem?

It can become one. Salts carried up by ground moisture erode mortar, brick and soft stone at the base of the wall, typically about 0.5 to 1.2 m above the ground, where loads are highest. Most cases are a damp specialist's job; an engineer is needed when cracking, bulging or deep decay affects stability.

What is the difference between undersetting and underpinning?

Undersetting replaces the base of a wall in short sections with a new damp-proof course. Underpinning deepens or strengthens footings after structural movement. They solve different problems and shouldn't be confused.

Does undersetting need an engineer?

Not always. High walls and thick rubble walls can need temporary support and an engineer's sequence while sections are cut out. We design that support; the damp specialist does the undersetting.

Is it salt damp or footing movement?

Salt damp shows as white salts, fretting mortar and flaking brick or stone low on the wall. Cracks that run up through the wall, step through the brickwork or open and close with the seasons usually point to movement. See salt damp or structural cracking.

Do you do salt damp treatment?

No. We never sell, recommend a contractor for or carry out salt damp treatment, damp-proof injection or undersetting. Our assessment is about the structure only.

How much does a salt damp structural assessment cost?

From $990 + GST ($1,089 inc GST) for a site inspection and report. A desktop review of photos starts at $350 + GST ($385 inc GST).

Can an air drain make things worse?

It can. An air drain dug beside a footing changes the moisture in the clay under it, and guidance written for SA heritage bodies warns against installing one in reactive clay without geotechnical engineering advice.

Should old walls be repointed with cement?

Generally not. Hard cement mortar and render can trap moisture and salts in old bluestone and soft brick and push the damage higher. Lime mortar usually suits old masonry; the damp specialist or stonemason advises on the mix.