Gloved hands holding a clipboard checklist and a torch at the front wall of a bluestone villa with red-brick quoins

Homeowners · Buyers · Landlords

Structural inspection and report for Adelaide homes

An independent engineer inspects the structure of your house, finds the cause of the cracks, sagging or movement, and sends a report in plain English. We have no repair to sell, so the report is only about your building.

  • From $990+ GST ($1,089 inc GST), full report
  • Under 20 minaverage time to a fixed quote
  • 3 optionsdesktop review, letter or full report
Quote requestMon–Fri 8am–5pm

Get a fixed quote for your inspection

Photos of the cracks or problem, the suburb and any deadline are usually enough.

We reply with a fixed quote in under 20 minutes on average, during business hours.

Engineering only
Full report from $990 + GST
Quotes in under 20 min on average
NCC & Australian Standards

In short

A structural inspection is an engineer's check of the parts of a house that carry load: footings, walls, floors and roof framing. Across Greater Adelaide and the Adelaide Hills, a full inspection and report starts from $990 + GST ($1,089 inc GST). A site visit with a letter of advice starts at $550 + GST, and a desktop review of photos at $350 + GST.

Fee
Full report from $990 + GST ($1,089 inc GST)
Quote
Fixed, in under 20 min on average (business hours)
You receive
A report: cause, severity and next steps

Signs to act on

When should you book a structural inspection?

Book a structural inspection when something in the house has changed and you want to know why: a crack that is new or growing, a door that no longer closes, a floor that has started to slope. The sooner the cause is found, the smaller the fix tends to be.

  • Cracks in bluestone, sandstone, brick or plaster that are wider than a few millimetres, stepped, or opening further.
  • Doors and windows that stick, swing open or have gaps that weren't there before.
  • Sloping or springy floors, cracked tiles, or gaps opening under skirtings.
  • Sagging ceilings or roof lines, or walls that lean or bulge.
  • After changes: a wall removed, an extension added, or excavation next door.
  • Before you buy: when the building inspector writes "refer to a structural engineer". See pre-purchase structural inspections.
12.2%of South Australian houses had structural problems (11% nationally)
6.5%had major cracks in ceilings or floors, the highest share of any state or territory

ABS data for 2019–20, as reported by InDaily. Much of Adelaide sits on highly reactive clay; every site needs its own classification.

Printed engineer's report with photo pages, a crack-width gauge card, glasses, a red pen and a laptop showing a floor plan
Figure 1Every inspection ends in a report: what was found, what it means and what to do next.

What we check

What does the engineer check in a house inspection?

The engineer checks every part of the house that carries load, and the ground and water around it, because in Adelaide the cause of a crack is usually below the floor rather than in the wall.

Walls and cracks

Bluestone, sandstone, double brick and brick veneer. Each significant crack is located, measured, photographed and rated against the AS 2870 damage categories.

Floors and levels

Slab and timber floors, cracked tiles and gaps under skirtings. Floor levels are taken where they help show which way the house has moved.

Openings and lintels

Doors and windows out of square, cracks above openings, and the lintels and brick arches that carry the wall over them.

Roof framing and ceilings

Sagging, cornice cracks, roof spread pushing walls outward, and the framing itself where the roof space is safe to enter.

Footings and subfloor

Visible footings, slab edges and the subfloor of timber floors. Footings can be exposed by a small hole where the cause can't be found otherwise.

Drainage, trees and site

Downpipes, stormwater, leaks, paving falls, nearby trees, retaining walls and how the block slopes.

Choosing

Which inspection do you need?

Choose by the question you need answered: a desktop review for a first opinion, a site visit and letter for one clear issue, or a full inspection and report when the cause is unclear or the report will be relied on by others.

OptionWhat it isBest forFrom, ex GSTinc GST
Desktop reviewAn engineer reviews your photos, plans or an existing report. No site visit.A first opinion, anywhere in South Australia$350$385
Site inspection with a letter of adviceA visit focused on one issue, with a short written letter.A single crack, a sagging beam, one wall$550$605
Structural inspection and full reportThe whole structure inspected, with a report on cause, severity and next steps.Several symptoms, a dispute, a lender, an insurer or a sale$990$1,089

Starting fees for a typical house. Larger houses, difficult access or extra testing are priced in your fixed quote before anything is booked. See all prices.

Not sure which one? Send photos and a few lines about what you've noticed. The fixed quote recommends the option that answers your question, in under 20 minutes on average, during business hours.

Get a fixed quote

The report

What's in a structural engineer's report?

A structural engineer's report records what was found, explains the likely cause in plain English and sets out what to do next, in an order that makes sense: fix the water first, monitor if the answer isn't clear, repair the structure only where it is needed.

Structural inspection report · Observation register extractExample only · illustrative data, not a real property
Example
PropertyExample villa, Suburb
WallsBluestone, brick quoins
FloorsTimber on stumps
AccessInside, outside, roof space
RefLocationObservationMeasuredLikely causePriority
1Front bedroomStepped crack from the window head4 mm, Cat 2Front corner footing settling where a downpipe dischargesFix water now
2HallDoor binding, floor falls to the side wall18 mm over 3 mSame movement as item 1Monitor
3Roof spaceCeiling joists not tied to rafters on one sideGap at wall plateRoof spread pushing the side wall outwardRepair
4KitchenFine crack at the cornice<0.1 mm, Cat 0Shrinkage of the plasterCosmetic

Illustrative example only, not a real property or result. Crack categories follow AS 2870 Appendix C.

  • The scope of the inspection, what could and couldn't be seen, and the documents reviewed
  • Photos and measurements of each significant crack, with its AS 2870 damage category
  • The likely cause, with the evidence for it, and whether movement looks ongoing
  • Recommendations in order of priority, and whether a repair needs design or approval
  • Any further checks, such as a plumbing leak test, site classification or crack monitoring

How it works

How does a structural inspection work?

  1. Step 1

    Send photos and the address

    Tell us what you've noticed and when it started, plus any deadline from a sale, a builder or an insurer.

  2. Under 20 min on average

    Get a fixed quote

    During business hours (Mon–Fri 8:00am–5:00pm): the fee, the inspection date and the report date, before anything is booked.

  3. On site

    Inspect and measure

    Cracks, levels, framing, footings and the site, inside and out.

  4. On the date in your quote

    Your report

    In plain English: the cause, how serious it is and the next steps.

  5. Only if needed

    Design a repair

    Drawings and calculations for your builder and certifier, for example underpinning or a new beam. We design; any builder can build it.

Structural inspection and full report

Fixed fee, agreed before we start

$990+ GST · $1,089 inc GST · starting price

Site visits across Greater Adelaide and the Adelaide Hills, from Norwood and Unley to Elizabeth, Morphett Vale and Mount Barker. Desktop reviews anywhere in South Australia.

Mostly worried about cracks?

Our crack and footing movement report maps every crack and finds the cause. Read cracks in walls: when to worry first if you're unsure.

FAQ

Structural inspection FAQs

Still unsure? Call 08 7083 9853 or send photos for a fixed quote.

How much does a structural inspection cost in Adelaide?

A full inspection and report starts from $990 + GST ($1,089 inc GST). A site visit with a letter of advice starts at $550 + GST ($605 inc GST) and a desktop review of photos at $350 + GST ($385 inc GST). You get a fixed quote before anything is booked.

What is the difference between a structural inspection and a building inspection?

A building inspector surveys the whole property for defects. A structural inspection is an engineer's assessment of the structure only: why it moved, whether it is still moving and what would fix it. See building inspector or structural engineer.

When will I get the report?

The fixed quote states when the report will be ready, so you know before you book. If you have a deadline, such as settlement or a builder's start date, tell us with your request.

Do you need to get into the roof space and subfloor?

Where it is safe, yes. Roof framing and the footings under a timber floor often explain what the cracks inside are showing. Tell us about access when you ask for a quote.

Can you inspect from photos instead of visiting?

Often, for a first opinion. A desktop review of photos and plans starts at $350 + GST and is available anywhere in South Australia. If the photos can't answer the question, we say what would.

Will the report tell me who should fix it?

No. The report sets out what the repair involves, in terms any builder can price. We never sell, recommend a contractor for or carry out repairs.

Do the repairs need council approval?

It depends on the work. Repairs that don't affect the structural soundness of the house are usually exempt, removing a load-bearing wall needs approval, and underpinning usually needs building consent; we confirm with your council or certifier.