Concrete column in an older car park with a crack and spalled concrete exposing rusty reinforcement, with the city skyline beyond

Owners · Buyers · Tenants · Property managers

Commercial building inspections in Adelaide

Structural condition assessments, defect reports, concrete deterioration reports and change of use assessments for offices, shops, warehouses, car parks and older stone and brick buildings. Reports with priorities you can budget for, from an engineer with no repair to sell.

  • Fixed quoteper project, before we start
  • Under 20 minaverage time to a fixed quote
  • Documentedfor your certifier
Quote requestMon–Fri 8am–5pm

Get a fixed quote for your inspection

Send the address, the type and size of building, photos of what concerns you and why you need the report.

We reply with a fixed quote in under 20 minutes on average, during business hours.

Documented for your certifier
Fixed fee per project
Quotes in under 20 min on average
NCC & Australian Standards

In short

A commercial building inspection by a structural engineer checks the frame, floors, walls, roof structure and visible footings of an existing building, plus cracking, corrosion and concrete spalling. We prepare condition assessments, defect reports, pre-purchase and pre-lease reports and change of use assessments across Greater Adelaide, each priced by fixed quote. We never quote the repair.

Fee
Fixed quote per building
Quote
In under 20 min on average, business hours
You receive
A report with photos and priorities

Choosing a report

Which commercial building inspection do you need?

The inspection you need depends on the question you're asking: what condition the building is in, whether it suits a new use, what caused a defect, or how far concrete has deteriorated.

ReportWhen you need itWhat it covers
Structural condition assessmentPlanning maintenance, budgeting, or before refinancing or leasingFrame, floors, walls, roof structure and visible footings, with repair priorities
Change of use assessmentA new use with heavier floor loads, or a council or certifier asking for evidenceFloor and roof capacity for the new use, and any strengthening needed
Commercial defect reportCracks, movement, sagging or water damage you need explainedThe likely cause, how serious it is and the repair to design
Concrete deterioration reportSpalling or rust stains in a car park, balcony or concrete frameMapping of damage, likely cause, make-safe advice and a repair scope
Pre-purchase or pre-lease inspectionBefore you buy or sign a leaseCondition of the structure, defects that matter, likely scale of repairs
Dilapidation reportBefore demolition, excavation or construction next doorA dated photo record of existing condition. See dilapidation reports

Defects in new or recent building work, or a dispute with a builder? See building defect reports.

Concrete car parks and balconies

What causes concrete spalling in car parks and balconies?

Concrete spalls when the steel reinforcement inside it rusts. Rust takes up more room than steel, so it cracks the concrete along the bar and eventually pushes the cover off.

Steel in concrete is protected while the concrete around it stays alkaline. Two things break that protection down over the years:

  • Carbonation: carbon dioxide from the air slowly lowers the alkalinity from the surface in. Where the cover to the steel is thin, it reaches the bars sooner.
  • Chlorides: salt from sea air along the coast, or carried in on vehicles, breaks down the protection even in alkaline concrete.

Water speeds both up. Cracks, leaking joints, failed membranes and blocked drains let it reach the steel. Older car parks, beachside apartment balconies and exposed concrete frames are the usual places to find it.

What the report gives you

We map the cracking, rust staining, hollow-sounding concrete and spalls, identify the likely cause, and set out what to make safe now, what to repair and what to monitor. The repair scope is written so contractors can price the same thing.

What you seeWhat it usually meansPriority
Rust stains on the surfaceReinforcement has started to corrodeInspect and plan
Cracks along a bar lineCorrosion is pushing on the coverRepair soon
Hollow-sounding concreteThe cover has separated from the steelMake safe, then repair
Spalled concrete, exposed barsAdvanced corrosion and loss of steel sectionMake safe now

A general guide only. The inspection sets the priority for each location.

Falling concrete

Spalls over a walkway, parking bay or entry can drop without warning. Fence off the area below until an engineer has inspected it.

Change of use

When does a change of use need a structural engineer?

A change of use needs a structural engineer when the new use loads the floors or roof more heavily, or when the council or certifier needs evidence that the existing structure suits the new classification. In South Australia a change that alters the building's NCC classification counts as building work (PDI Regulations, reg 3E), so it goes through Building Rules Consent.

FromToWhat we check
OfficeGym or fitness studioHigher floor loads, dropped weights and vibration from classes
OfficeArchive or storageCompactus and shelving loads, far heavier than office loads
ShopRestaurant or function roomCrowd loads on the floor, and kitchen plant on the roof
WarehouseShowroom or indoor recreationPublic use of floors and mezzanines, new openings and fit-out loads
HouseOffice or consulting roomsDomestic floors now carrying office loads and filing
Upper floors of an older buildingApartmentsFloor capacity, new walls and services, with fire and sound separation set by the designer
Empty steel portal frame warehouse with tall columns and rafters, roller doors, high-bay lights and a clean concrete floor
Figure 1An empty warehouse before a change of use: the slab, frame and roof are checked for the new loads.

What the PDI Act says

When a building consent application involves a change of classification, and the council or certifier considers the building unsafe or structurally unsound, they can require upgrade work to the Building Rules to the extent reasonably necessary (s134). An owner must not let a building be occupied unless it is built, maintained and operated to the classification that suits its use (s151). Imposed floor loads come from AS/NZS 1170.1, and NCC 2022 (as amended) applies until 30 April 2027.

Rough-faced sandstone wall with red-brick quoins around a timber sash window, weathered mortar and a hairline crack running from the sill
Figure 2Old sandstone and brick: lime mortar, salt damp and earlier alterations all affect how the wall carries load.

Older buildings

How do you inspect older stone and brick commercial buildings?

Older commercial buildings in Adelaide are inspected for how they were actually built: bluestone, sandstone and brick laid in lime mortar, timber floors and roofs, and a century of alterations. Many older shopfronts and warehouses still stand on their original stone or brick walls.

  • Salt damp: Adelaide is known for it. We report where decay at the base of a wall affects its stability; damp-proof course work is a damp specialist's job.
  • Earlier openings: shopfront widenings and removed walls are checked for what now carries the load.
  • Earthquake: Adelaide's earthquake hazard is the highest of the capital cities and is part of our design checks for any strengthening.
  • Heritage: State and local heritage places, and buildings in the Historic Area Overlay, have their own approval paths. Where demolition relies on the building's structural integrity being beyond reasonable repair, the engineer's report is central.

See bluestone and heritage buildings and the guide to looking after a bluestone home.

The inspection

What does a commercial structural inspection include?

A commercial structural inspection includes a review of what's known about the building, an inspection of everything that carries load, and a report with priorities.

  • Review of existing drawings, earlier reports and the building's history, where available
  • Inspection of the frame, floors, walls, roof structure and visible footings
  • Cracks located, measured and photographed; levels and deflections checked where they matter
  • Corrosion, spalling and water entry mapped on concrete and steel
  • The likely cause of each defect, and how serious it is
  • Priorities: make safe, repair, monitor or no action
  • The limits of the inspection, including areas we couldn't reach

Building inspector or engineer?

A building inspector reports on general condition. A structural engineer explains what's moving or deteriorating, why, and what the fix involves. Our guide compares the two: building inspector or structural engineer. For homes, see pre-purchase structural inspections.

What to send for a quote

  • The address, building type and approximate floor area
  • Photos of the cracks, spalling or area of concern
  • Any drawings or earlier reports you have
  • Why you need the report: purchase, lease, change of use, maintenance or a dispute

You'll have a fixed quote in under 20 minutes on average, during business hours, with the inspection scope and what the report will cover. Get a fixed quote

FAQ

Commercial building inspection FAQs

Still unsure? Call 08 7083 9853 or send photos for a fixed quote.

What is a structural condition assessment?

It's an engineer's inspection of a building's frame, floors, walls, roof structure and visible footings, with a report on defects, their likely causes and how urgent each repair is. Owners use it to plan maintenance and budgets.

How much does a commercial building inspection cost?

Commercial inspections are priced by fixed quote per building, based on its size, the access needed and whether any testing is likely. Send the address and photos and you'll have the fixed fee in under 20 minutes on average, during business hours.

Is concrete spalling dangerous?

It can be. Loose concrete can fall from soffits, columns and balcony edges, and the rusting steel behind it is losing strength. Fence off the area below and have an engineer inspect it.

Does a change of use need approval in SA?

Usually. A change in the use of land is development under the PDI Act unless the Code treats it as a minor change or within the same use class. If the change alters the building's NCC classification, it also counts as building work and needs Building Rules Consent. Your council or certifier confirms what applies.

Can you inspect a building before we buy or lease it?

Yes. A pre-purchase or pre-lease structural inspection reports the condition of the structure, the defects that matter and the likely scale of repairs, so you know before you commit.

Do you test the concrete?

On site we look, sound for hollow concrete and measure cover where needed. If tests such as carbonation depth or chloride content would change the advice, the report says which and why, and any testing is quoted before it happens.

Can you inspect old stone and heritage commercial buildings?

Yes. Bluestone, sandstone and brick buildings are assessed on their own terms. In the Historic Area Overlay, demolition can rely on the original building's structural integrity or safe condition being beyond reasonable repair, so the engineer's report carries weight.

Do you carry out the repairs?

No. We are engineering only: we inspect, diagnose and specify the repairs, and any contractor can price and carry them out. We don't recommend contractors.