New concrete sleeper retaining wall with galvanised steel posts along a terraced backyard, a Colorbond fence on top, stone steps and lawn, with wooded hills behind

Homeowners · Builders · Landscapers

Retaining wall engineering for sloping blocks

In South Australia a wall that retains more than 1 m of ground is development and needs approval, and so does a wall and fence over 2.1 m from the low side. We design walls your builder can price and your council or certifier can approve.

  • From $790+ GST ($869 inc GST)
  • Under 20 minaverage time to a fixed quote
  • 1 mretained before a wall needs approval
Quote requestMon–Fri 8am–5pm

Get a fixed quote for your wall

A photo of the slope, the height and length you need, and anything above the wall (a driveway, house, pool or fence) is usually enough.

We reply with a fixed quote in under 20 minutes on average, during business hours.

Engineering only
Walls from $790 + GST
Quotes in under 20 min on average
NCC & Australian Standards

In short

A retaining wall in South Australia needs approval if it retains more than 1 m of ground, or at any height within 100 m of the coast, in a flood overlay or on a heritage place. A wall with a fence on top also needs approval once the two exceed 2.1 m from the low side. Our Adelaide wall designs start from $790 + GST ($869 inc GST).

Fee
From $790 + GST ($869 inc GST)
Approval needed
Over 1 m retained, or wall plus fence over 2.1 m
You receive
Drawings, calculations and footing details

South Australian rules

When does a retaining wall need approval in SA?

A retaining wall needs approval in South Australia when it retains a difference in ground levels of more than 1 m. Below 1 m it is not development, unless the exemption is switched off by the location or a fence on top.

The wallApprovalNotes
Retains 1 m or lessNot development (exempt)Measured as the difference in ground levels, not the height of the blocks
Retains more than 1 mDevelopment: needs approvalPlans show the location, minimum and maximum heights, elevations at 1:200 and materials
Tiered or stepped wallsAssessed on the overall level differenceTwo 700 mm tiers retaining 1.4 m in total are over the limit
Within 100 m of the coast, in a flood zone or overlay, or on a local or State heritage placeExemption doesn't applyApproval needed at any height
Wall plus fence over 2.1 m, measured from the low sideNeeds approvalCouncils ask for engineer's footing calculations and connection details
Masonry fence over 1 m on a wallFence exemption doesn't applyDesign the wall for the fence's weight and wind load
On an SA Water easementSA Water's approval neededApplies to walls, fill and excavation on the easement
Excavation or fill over 9 m³ on coastal landDevelopmentRelevant for walls on beachside blocks

Planning, Development and Infrastructure (General) Regulations 2017, Schedule 4 clause 4(1)(d) and (f), Schedule 3 clause 5 and Schedule 8; Law Handbook SA. Your council or certifier confirms what your wall needs. More in our guide to retaining wall rules in SA.

Check your wall in four steps

  1. Is it within 100 m of the coast, in a flood overlay or on a heritage place?

    Check the property on SAPPA or with your council.

    Yes: approval at any heightNo: go to 2
  2. Does it retain more than 1 m in total?

    Add up the tiers. Measure the soil retained, not the blocks.

    Yes: approval and an engineer's designNo: go to 3
  3. Will a fence sit on top?

    Measure wall plus fence from the low side.

    Over 2.1 m: approval and footing calculationsNo: go to 4
  4. Does it hold up a driveway, house, pool or steep slope?

    Exempt walls still have to stand up.

    Yes: get it designedNo: usually exempt

Height limits before approval is needed

  • Retaining wallGround retained, any type of wall1 m
  • Masonry fenceFence exemption limit1 m
  • Other fencesFrom the lower ground level2.1 m
  • Wall plus fenceMeasured from the low side2.1 m
Figure 1Retained height is the difference in ground levels across the wall. A fence is measured from the lower of the two finished ground levels.Source: PDI (General) Regulations 2017, Schedule 4 clause 4(1)(d) and (f); Law Handbook SA.

Exempt isn't the same as safe

The 1 m rule only decides whether you need approval. A 900 mm wall under a driveway or beside a house footing carries real load, and it fails the same way a tall one does if its footing or drainage is wrong.

What's included

What does a retaining wall design include?

A retaining wall design gives your builder or landscaper everything needed to price and build the wall, and your council or certifier the plans and calculations to approve it.

  • A review of the site from photos, a survey or a visit, and of the soil, with a site classification where the design needs one
  • The loads behind the wall: the slope above, a driveway, a house footing, a pool or a fence on top
  • Wall type, footing size, post spacing and depth, and reinforcement
  • Drainage: free-draining backfill, an ag pipe and where the water goes
  • Plans showing the location, minimum and maximum heights, elevations at 1:200 and materials
  • Calculations for council or your certifier, and inspections or a certificate if your consent lists them
Fixed fee, agreed first

Retaining wall engineering

$790+ GST · $869 inc GST · starting price

A typical residential wall in Greater Adelaide. Taller, longer, tiered or heavily loaded walls are priced in your fixed quote, and design from photos and plans is available anywhere in South Australia.

Sandstone block retaining wall sitting above a concrete sleeper retaining wall with steel posts in front of a modern house, with gum trees and the Adelaide Hills behind
Figure 2A tiered wall in the Adelaide Hills. For approval, the two tiers count as one wall: the overall difference in ground levels is what's measured.

Key takeaways

  • Over 1 m of retained ground needs approval; tiers are added together.
  • Within 100 m of the coast, in a flood overlay or on a heritage place, any height needs approval.
  • Wall plus fence over 2.1 m from the low side needs approval and footing calculations.
  • Whoever changed the ground level generally pays to retain it.

Wall types

Which type of retaining wall suits your block?

The right wall depends on the height, the soil, what sits above it and how much room there is for a footing. This comparison is general engineering practice; your design sets the details.

WallHow it holds the soilOften used forEngineering notes
Concrete sleeper and steel postPrecast sleepers slotted between steel posts concreted into the groundBackyard terraces and boundary walls where space is tightPost size, depth and spacing depend on the soil, the height and any fence; galvanising matters
Reinforced concrete blockCore-filled, reinforced blockwork on a reinforced footingTaller walls, walls beside driveways and under fencesFooting width and reinforcement designed; drainage behind is essential
Interlocking block with geogridStacked blocks tied back into the soil with layers of geogridLandscaped slopes with room behind the wallGeogrid length sets how far back the wall reaches, so check boundaries and services
Sandstone or limestone blocksHeavy blocks resist the soil by their own weight (a gravity wall)Garden walls, Hills properties and rebuilding old stone wallsNeeds a firm base and drainage; old dry-stacked walls can bulge when drainage clogs
GabionWire baskets filled with rock, acting as a gravity wallSlopes that need to drain freelyNeeds width and a level base; flexes more than a rigid wall
Timber sleeperSleepers between timber or steel postsLow garden wallsShorter life in contact with soil; best kept low

Neighbours

Who pays for a retaining wall between neighbours?

Generally, the owner who changed the natural ground level pays to retain it. That applies whether the change was made by you or by a previous owner, and councils don't decide who pays.

  • Cut or fill on one side: that owner retains the earth they altered from natural ground level.
  • Changes on both sides: the cost is shared in proportion. 300 mm of fill on one side against 700 mm of cut on the other splits 30/70.
  • New work next to an old wall: whoever fills or excavates beside an existing wall pays for the support it then needs.
  • Footings: they must not cross the boundary unless both owners agree.
  • Disputes: they go to the Magistrates Court (Minor Civil). A retaining wall isn't a fence under the Fences Act 1975.

An engineer's drawing that shows the natural ground line, the cut and the fill makes these conversations much easier. Send us a level survey and we show those lines on the design.

Building or excavating next to a neighbour's house? A dilapidation report records its condition before work starts, and our guide to neighbour excavation in SA explains the notice.

Digging near the boundary: section 139

Under section 139 of the Planning, Development and Infrastructure Act, excavation that cuts a plane sloping down at 1 vertical to 2 horizontal from 600 mm below natural ground at the boundary, or fill within 600 mm of it, needs a Form 1 notice to the neighbour at least 20 business days before work starts. The neighbour can have a professional engineer specify shoring or underpinning, at the reasonable cost of the owner doing the work.

Does the excavation trigger a section 139 notice?

The section 139 trigger plane next to a boundary in South Australia Cross-section: the neighbour's house on the left of the boundary and your site on the right. A dashed line starts 600 millimetres below natural ground at the boundary and slopes down into your site at 1 vertical to 2 horizontal. An excavation on your site goes deeper than that line, so it cuts the plane and a notice to the neighbour is needed. Neighbour's house Boundary Your site Excavation 600 mm 2 1 Cuts the plane Trigger plane: 1 vertical : 2 horizontal
Figure 3A simplified section of the section 139 trigger (Planning, Development and Infrastructure Act 2016, with regulation 64). Excavation on your land that cuts a plane drawn at 1 vertical to 2 horizontal from 600 mm below natural ground at the boundary, or fill within 600 mm of the boundary (other than 200 mm or less for landscaping), needs a Form 1 notice to the neighbour at least 20 business days before work starts. Whether the neighbour's footing actually moves is a separate engineering question.Illustrative diagram, not to scale or to a specific site. Prepared by Adelaide Structures.

Slopes, Hills and coast

What changes on Adelaide Hills and other sloping sites?

On sloping sites the walls get taller, the loads behind them get heavier and the water has further to run, so the design work grows. These are the issues we design for most often on Hills, foothill and coastal blocks.

Loads above the wall

Driveways, carports, house footings and pools close to the top of a wall push on it. The design includes them.

Drainage

Water behind a wall adds pressure and is the most common reason walls lean. Backfill, an ag pipe and a discharge point are drawn, not assumed. See drainage plans.

Rock and reactive clay

Shallow rock changes how posts and footings are founded, and reactive clay swells against a wall when wet. Much of Adelaide sits on highly reactive clay; every site needs its own classification.

Tiered walls

Terracing a slope in two walls doesn't avoid approval: the overall level difference counts, and a lower wall carries the upper one.

Fences in the Hills

The fence exemption doesn't apply in the Hills Face Zone or the Significant Landscape Protection Overlay, so a fence on your wall may need approval there.

Beachside blocks

Within 100 m of the coast, retaining walls lose their exemption, and excavation or fill over 9 m³ is development.

We design walls across Greater Adelaide and the Adelaide Hills, including the slopes of the Adelaide Hills, Blackwood and Belair and Mount Barker, wall-and-fence jobs in Salisbury, and coastal blocks in Glenelg and Henley Beach.

FAQ

Retaining wall FAQs

Still unsure? Call 08 7083 9853 or send photos for a fixed quote.

Does a retaining wall need council approval in SA?

Yes, if it retains more than 1 m of ground. Below that it is usually exempt, except within 100 m of the coast, in a flood zone or overlay, or on a local or State heritage place. Tiered walls are measured on the overall difference in ground levels.

Can I put a fence on top of a retaining wall?

Yes, if the wall is designed for it. A fence adds wind load to the top of the wall. If wall and fence together are more than 2.1 m measured from the low side, approval is needed, and councils such as Salisbury ask for engineer's footing calculations and connection details.

How much does a retaining wall engineer cost in Adelaide?

Our retaining wall designs start from $790 + GST ($869 inc GST) for a typical residential wall. Taller, longer or heavily loaded walls are priced in a fixed quote, sent in under 20 minutes on average, during business hours.

Who pays for a retaining wall between neighbours in SA?

Generally, the owner who changed the natural ground level retains the soil they cut or filled. Where both sides changed it, the cost is shared in proportion, for example 30/70 for 300 mm of fill against 700 mm of cut. Councils don't apportion costs; disputes go to the Magistrates Court (Minor Civil).

Is a retaining wall covered by the Fences Act?

No. SA's Fences Act 1975 deals with dividing fences, and a retaining wall is not treated as a fence. Its footings also can't cross the boundary unless both owners agree.

My neighbour is digging near the boundary. What are my rights?

If the excavation cuts a plane sloping down at 1 vertical to 2 horizontal from 600 mm below natural ground at the boundary, you must be served a notice at least 20 business days before work starts. You can then have a professional engineer specify shoring or underpinning, at the reasonable cost of the owner doing the work. See neighbour excavation.

Do walls under 1 m need an engineer?

Not for approval, but a low wall can still fail if it holds up a driveway, a house footing or a pool, or if the drainage behind it clogs. We design these too, from the same starting price.

Do you build retaining walls?

No. We design and document the wall; any builder or landscaper can build it from our drawings. We never recommend a contractor.