Approvals

Retaining wall rules in South Australia

When a retaining wall needs approval in South Australia: the 1 m exemption and its exceptions, the 2.1 m wall-plus-fence rule, section 139 notices, who pays between neighbours and where disputes go.

New concrete sleeper retaining wall with galvanised steel posts along a terraced backyard, with a Colorbond fence on top and garden steps

In short

In South Australia a retaining wall that retains 1 m or less of ground is not development, so it needs no approval, unless it is within 100 m of the coast, in a flood overlay or on a heritage place. A fence on top counts: wall plus fence over 2.1 m, measured from the low side, needs approval. Cost disputes between neighbours go to the Magistrates Court.

Key takeaways

  • Up to 1 m retained: not development (PDI Regulations, Schedule 4 clause 4(1)(f)). Tiered walls are measured on the overall difference.
  • No exemption within 100 m of the coast, in a flood zone, subzone or overlay, or on a local or State heritage place.
  • Wall plus fence over 2.1 m from the low side needs approval, and councils such as Salisbury ask for the engineer's footing calculations.
  • Digging or filling near a boundary can trigger a section 139 notice, served at least 20 business days before work starts.
  • Each owner retains the ground they, or a previous owner, changed. Disputes go to the Magistrates Court (Minor Civil), not the council.

Retaining walls cause more neighbour arguments than almost any other small structure, and the rules in South Australia are spread across regulations, council pages and case law. This guide pulls them together: when a wall needs approval, how a fence on top changes the answer, what happens when someone digs near a boundary, and who pays when a wall between two blocks fails.

Retaining wall rules in SA: quick facts

No approval
Retains 1 m or less (overall, for tiered walls)
Always approval
Within 100 m of the coast, flood overlays, heritage places
Wall plus fence
Over 2.1 m from the low side needs approval
Section 139 notice
At least 20 business days before digging or filling
Disputes
Magistrates Court (Minor Civil), not council
Our design
From $790 + GST ($869 inc GST)

When does a retaining wall need approval in SA?

A retaining wall needs approval when it retains a difference in ground levels of more than 1 m, or when it sits somewhere the exemption doesn't apply. Under Schedule 4 clause 4(1)(f) of the General Regulations, a wall retaining 1 m or less is not development. The exemption is lost:

  • In a designated flood zone, subzone or overlay in the Planning and Design Code
  • Within 100 m of the coast, measured from the mean high water mark at spring tide
  • On a local heritage place or a State heritage place

Tiered walls are measured on the overall difference in level, so two 700 mm walls stepping up a slope count as 1.4 m. Building a wall on an SA Water easement, or filling or excavating there, also needs SA Water's approval, applied for at the same time as council.

  1. Does the wall retain more than 1 m, counting all tiers?

    Measure the difference between the ground levels on each side.

    Yes: development approval and an engineer's designNo: go to the next question
  2. Is it within 100 m of the coast, in a flood overlay or on a heritage place?

    Check the zone and overlays for your site in the Code.

    Yes: approval needed, even under 1 mNo: go to the next question
  3. Will a fence on top take the total over 2.1 m from the low side?

    Measure from the lower finished ground level.

    Yes: approval, with footing calculationsNo: go to the next question
  4. Will you dig or fill near the boundary?

    The section 139 triggers are explained below.

    Yes: serve a Form 1 notice at least 20 business days aheadNo: usually no approval; a design is still wise

Does a fence on top of a retaining wall need approval?

Yes, once the wall and the fence together stand more than 2.1 m high, measured from the low side. A fence on its own is exempt up to 2.1 m, measured from the lower of the two finished ground levels, but a wall lifts the fence. The City of Salisbury asks for "engineer's design documentation including calculations for the footings and connection details" for these combinations.

SituationApproval?Rule
Wall retaining 1 m or less, outside the excluded areasNoSchedule 4 cl 4(1)(f)
Wall retaining more than 1 m (tiers measured overall)YesSchedule 4 cl 4(1)(f)
Any wall within 100 m of the coast, in a flood overlay or on a heritage placeYesSchedule 4 cl 4(1)(f)
Fence up to 2.1 m from the lower ground levelNo, with exceptionsSchedule 4 cl 4(1)(d)
Masonry fence over 1 m, or any pool safety fenceYesSchedule 4 cl 4(1)(d)
Wall plus fence over 2.1 m from the low sideYesLaw Handbook; council guidance
Wall, fill or excavation on an SA Water easementSA Water approvalSA Water encroachment rules

PDI (General) Regulations 2017, version of 29.10.2026. Other fence exceptions include Historic Area front fences, fences over 1 m within 6 m of a corner and some landscape overlays. Confirm with your council or certifier.

When do you need an engineer for a retaining wall?

You need an engineer's design for any wall that needs approval, and it is worth having one for lower walls that carry real load. Exempt only means no approval: a 900 mm wall holding up a driveway, a house footing or a neighbour's fence still has to stand up for decades.

Sandstone block wall above a concrete sleeper retaining wall in front of a modern house, with hills slopes behind
Figure 1Two walls stepping up a slope. For approval, tiered walls are measured on the overall difference in level, not each tier on its own.
  • Near a building: the wall's footing and the house footing affect each other
  • Under a driveway or parking area: vehicle loads push harder on the wall
  • Beside a pool: see pool engineering
  • On reactive clay: much of Adelaide sits on highly reactive clay, and wet clay pushes hard. Read reactive clay soils
  • Where water collects: drainage behind the wall is part of the design. Read stormwater rules in Adelaide

Our retaining wall engineering starts from $790 + GST ($869 inc GST) and gives your builder or landscaper drawings to price and build from, and your council or certifier what they need to assess.

What does a retaining wall application need to show?

A building consent application for a retaining wall must show its location, its minimum and maximum heights, elevations at 1:200 and its materials (Schedule 8 clause 2(1)(h)). The site plan at 1:500 also shows easements and trees, including "the location of any regulated tree on the site or on adjoining land". The engineer adds the calculations, the footing and the drainage. Read building approvals in SA for the whole process.

What if you dig or fill near the boundary?

Excavation or fill near a boundary can trigger section 139 of the PDI Act, which protects the stability of the neighbour's land and buildings. The triggers in reg 64 are:

  • Excavation that cuts a 1 vertical : 2 horizontal plane taken from 600 mm below natural ground at the boundary
  • Fill within 600 mm of the boundary, unless it is 200 mm or less and for landscaping

Does the excavation trigger a section 139 notice?

The section 139 trigger plane next to a boundary in South Australia Cross-section: the neighbour's house on the left of the boundary and your site on the right. A dashed line starts 600 millimetres below natural ground at the boundary and slopes down into your site at 1 vertical to 2 horizontal. An excavation on your site goes deeper than that line, so it cuts the plane and a notice to the neighbour is needed. Neighbour's house Boundary Your site Excavation 600 mm 2 1 Cuts the plane Trigger plane: 1 vertical : 2 horizontal
Figure 2A simplified section of the section 139 trigger (Planning, Development and Infrastructure Act 2016, with regulation 64). Excavation on your land that cuts a plane drawn at 1 vertical to 2 horizontal from 600 mm below natural ground at the boundary, or fill within 600 mm of the boundary (other than 200 mm or less for landscaping), needs a Form 1 notice to the neighbour at least 20 business days before work starts. Whether the neighbour's footing actually moves is a separate engineering question.Illustrative diagram, not to scale or to a specific site. Prepared by Adelaide Structures.

The building owner must serve an initial notice on Form 1 (Schedule 10A) at least 20 business days before work starts. The neighbour may then have a professional engineer specify shoring or underpinning, and the building owner pays the reasonable cost of that report and plans. The penalty for not complying is up to $10,000. A dilapidation report before work starts records the neighbour's house as it was. Read your neighbour is digging next door for the neighbour's side.

Who pays for a retaining wall between neighbours in SA?

Each owner pays to retain the ground that they, or a previous owner, changed from its natural level. The Law Handbook sets out how this works:

  • One owner changed the levels: that owner retains the earth and pays for the wall
  • Both changed them: the cost is shared in proportion, so 300 mm of fill on one side against 700 mm of cut on the other splits 30/70
  • Someone fills or digs next to an existing wall: they pay for the extra support it needs
  • Footings stay on your side: they must not cross the boundary unless both owners agree (Encroachments Act 1944)

Sharing the cost of a shared retaining wall

  • Owner who filled300 mm of fill30%
  • Owner who cut700 mm of cut70%
Figure 3Illustrative example: one owner filled 300 mm above natural ground, the other cut 700 mm below it, so the 1 m difference is shared 30/70.Source: Law Handbook (Legal Services Commission of SA) example.

A retaining wall is not a fence for the purposes of the Fences Act 1975: the Law Handbook says it "is not considered to be a fence and is covered by different laws". Fence notices and fence cost-sharing don't decide who pays for the wall underneath.

Where do retaining wall disputes go in SA?

To the Magistrates Court (Minor Civil Division). Councils don't apportion retaining wall costs between neighbours. Before it gets that far, an independent engineer's report helps both owners: it records the natural ground level where it can be worked out, the condition of the wall, the likely cause of any failure and the work needed. We report on the structure only and take no side in the dispute beyond the facts.

When to call a structural engineer

Call an engineer before the wall is built, or as soon as an existing one starts to move.

  • The wall will retain more than 1 m, counting all tiers, or sits near the coast or a flood overlay
  • A fence on top will take the total over 2.1 m from the low side
  • You'll dig or fill near a boundary, or your neighbour has served you a section 139 notice
  • An existing wall is leaning, cracking or bulging, or water seeps through it
  • You and a neighbour disagree about who should pay

A design your builder and certifier can use

Send a photo of the slope, the height you need and what sits above and below. Our retaining wall engineering starts from $790 + GST ($869 inc GST), with a fixed quote in under 20 minutes on average, during business hours. Get a fixed quote.

Sources

  1. Planning, Development and Infrastructure (General) Regulations 2017 (SA), version of 29.10.2026. Schedule 4 clause 4(1)(d) and (f), reg 3C, reg 64, Schedule 8 clause 2(1)(h), Schedule 10A
  2. Legal Services Commission of SA, Law Handbook: retaining walls, fences and neighbour excavation. Wall-plus-fence rule, tiered walls, who is responsible, section 139 and disputes
  3. City of Salisbury, Fencing
  4. SA Water, Encroachment over an easement (fact sheet)

FAQ

Retaining wall rules in SA: FAQs

Still unsure? Call 08 7083 9853 or send photos for a fixed quote.

Do I need approval for a retaining wall in SA?

You need approval if the wall retains more than 1 m of ground, or if it is within 100 m of the coast, in a flood zone or overlay, or on a local or State heritage place. Below 1 m and outside those areas, a retaining wall is not development.

How high can a retaining wall be without approval in SA?

Up to 1 m of retained ground, measured as the difference in ground levels. For tiered walls the overall difference counts, so two 700 mm tiers make a 1.4 m wall.

Does a fence on top of a retaining wall need approval?

It does when the wall and fence together are more than 2.1 m high, measured from the low side. Councils such as Salisbury then ask for the engineer's design, including footing calculations and connection details.

Who pays for a retaining wall between neighbours in SA?

Each owner is responsible for retaining the ground they, or a previous owner, changed from its natural level. Where both changed it, the cost is shared in proportion: 300 mm of fill against 700 mm of cut splits 30/70.

Is a retaining wall covered by the Fences Act?

No. The Law Handbook says a retaining wall "is not considered to be a fence and is covered by different laws". The Fences Act 1975 deals with dividing fences only.

What is a section 139 notice?

A notice under the PDI Act, on Form 1, that must be served on a neighbour at least 20 business days before excavation or fill near the boundary that could affect their land. The neighbour can have a professional engineer specify shoring or underpinning, at the building owner's cost.

Do I need an engineer for a retaining wall under 1 m?

Not for approval. A design is still wise when the wall holds up a driveway, a building, a pool or a boundary fence, or sits on reactive clay. Our retaining wall engineering starts from $790 + GST ($869 inc GST).

Where do retaining wall disputes go in SA?

To the Magistrates Court (Minor Civil Division). Councils don't apportion the cost of a retaining wall between neighbours.