Costs

How much does underpinning cost in Adelaide?

Adelaide underpinning contractors and referral sites publish ranges from about $5,000 to $80,000 or more. What moves the price on Adelaide's clay, what the engineering and approvals add, and why an independent assessment should come first.

Excavated pit beside the sandstone footing of an older house, with a new concrete underpin under the footing, timber shoring boards and dark clay

In short

Adelaide underpinning contractors and referral sites publish figures from about $5,000 for a single wall section to $80,000 or more for a full replacement. These are their figures, not ours, and inclusions vary. We don't sell underpinning: an independent assessment, from $350 + GST, tells you whether it's needed at all and, if it is, how much and where.

Key takeaways

  • Published Adelaide ranges run from about $5,000 for a single wall section to $40,000–$50,000 or more for larger jobs.
  • Full replacements are published at $30,000–$80,000 or more, and the widest published range reaches $100,000 or more.
  • On Adelaide's clay, the extent, the depth to stable ground, access and whether the cause is fixed move the price most.
  • Underpinning usually needs building consent; budget for the design, any soil investigation and the consent on top of the contractor's price.
  • Our independent second opinion starts from $350 + GST ($385 inc GST), from the quote, any reports and photos.

Underpinning is often the biggest repair bill an Adelaide homeowner faces, and two quotes for the same house can sit tens of thousands of dollars apart. This guide gathers the price ranges Adelaide businesses publish, explains what moves the price on Adelaide's reactive clay, and adds the engineering and approval costs that sit around the contractor's figure. We have no underpinning to sell, so every repair figure below is someone else's published range, not our price.

Underpinning cost in Adelaide: quick facts

Typical published range
$5,000–$50,000 or more
One wall section
$5,000–$15,000
Full replacement
$30,000–$80,000 or more
Approval
Usually building consent; we confirm with your council or certifier
Our second opinion
From $350 + GST ($385 inc GST)
Our crack report
From $990 + GST ($1,089 inc GST), on site

How much does underpinning cost in Adelaide?

Adelaide's published figures run from about $5,000 for a single wall section to $40,000–$50,000 for larger jobs, and $80,000 to $100,000 or more at the top end. The spread is wide because each source prices a different mix of jobs, and none of them has seen your house.

Published underpinning cost ranges, Adelaide sources

  • Underpinning · typical ranges$5k–$50k+
  • One wall section$5k–$15k
  • Full replacement$30k–$80k+
  • Underpinning · widest range$20k–$100k+
  • Resin injection$5k–$15k
  • Our quote second opinionfrom $350 + GST
$0$20,000$40,000$60,000$80,000$100,000
Figure 1Ranges as each source publishes them; GST treatment and inclusions vary or aren't stated, and the top of several ranges is open-ended ("or more"). Our fee is for reviewing a quote, ex GST, not the cost of the work.Source: Published price ranges from Adelaide underpinning contractors, referral sites and other local businesses, checked November 2026; GST and inclusions vary.
JobPublished range
Underpinning, typical jobs$5,000–$40,000, and up to $50,000 or more
A single wall section$5,000–$15,000
Full replacement$30,000–$80,000 or more
Underpinning, widest published range$20,000–$100,000 or more
Resin injection$5,000–$15,000

Same published sources as Figure 1, checked November 2026; GST and inclusions vary. These are other businesses' figures, not our prices: we don't sell, recommend a contractor for or carry out underpinning.

Do you need underpinning at all?

Often not. Most cracking in Adelaide houses traces back to water and clay: a leaking pipe, a downpipe emptying at the wall, ponding, or a tree drying one corner. Fix the cause and the clay can settle back into its seasonal rhythm, leaving cracks to be repaired once they stop moving. Underpinning is for footings that keep moving after the cause is dealt with, or that never had enough support.

That's why the diagnosis comes before the price. Cracks are graded on the AS 2870 damage scale, then watched through dry and wet months to see whether they are seasonal or still growing. Our cracks in walls guide explains how to read them.

What drives the cost of underpinning in Adelaide?

How much of the house needs support, how deep stable ground is and whether the cause has been fixed decide most of the price; the method's name matters less. Adelaide adds a few local factors.

Cost driverWhy it matters in Adelaide
ExtentOne corner, one wall or the whole perimeter. More length means more piers, pins or concrete.
Depth to stable groundThe state's 1996 soil study found Adelaide's deeper clays "equally reactive", and recent research models moisture changes to about 4 m. Deeper support means more digging or longer piles.
The houseMost Adelaide houses are solid masonry on dwarf wall footings or raft slabs. Heavy bluestone and double-brick walls need more support than a lightweight frame.
The causeA leak, a downpipe or a tree left unfixed can keep moving the house after it's underpinned. Fixing the cause can cost less than the repair.
TreesWithin the Regulated and Significant Tree Overlay, substantial damage to a regulated tree's roots needs approval, so digging beside one can add an approval and limit the method.
AccessNarrow side paths on older cottage lots, stairs and tight spaces mean hand digging, small rigs and more labour.
A close neighbourExcavation near the boundary can trigger a section 139 notice, and the neighbour may have a professional engineer specify protection at the building owner's cost. A dilapidation report helps.
HeritageA State heritage place gets none of the Schedule 4 exemptions. Read looking after a bluestone home.
Contract of $20,000 or moreDomestic work at this size that needs approval needs the builder's building indemnity insurance, and the builder must give you the certificate before work starts.

Three common underpinning methods, side by side

Mass concrete underpinning, screw piles and resin injection compared Three simplified sections of a wall on a strip footing. In the first, a concrete block is cast under the footing down to firmer ground. In the second, a steel screw pile beside the footing reaches firmer ground and is connected to the footing with a bracket. In the third, resin is injected through small tubes into the soil under the footing. firmer ground firmer ground firmer ground 1 · Mass concrete 2 · Screw pile 3 · Resin injection
  • 1 · Mass concrete: concrete is cast in short sections under the footing, down to firmer ground.
  • 2 · Screw piles or piers: steel piles are driven or screwed to a firmer layer and tied to the footing with brackets or a new beam.
  • 3 · Resin injection: expanding resin is injected into the soil under the footing to fill voids, densify it and sometimes lift the footing.
Figure 2Simplified sections, not to scale. The right method depends on the soil, the cause of movement and the building, so the diagnosis has to come first. We design and certify; we don't sell any method.Illustrative diagram. Prepared by Adelaide Structures.

Does the underpinning method change the cost?

Yes, but compare methods only after the diagnosis, because the right one depends on the clay, the cause and the building. Mass concrete underpinning digs to firmer ground in short sections; screw piles reach deeper ground with less excavation; resin injection lifts or stiffens the soil under the footing. Published Adelaide figures put resin injection at about $5,000–$15,000 and the widest published underpinning range at $20,000–$100,000 or more, but cheaper per job isn't cheaper overall if the method doesn't suit the ground and has to be done twice.

Undersetting is not underpinning

In old stone and brick homes, undersetting replaces the base of a salt-damp wall in sections with a new damp-proof course. It is a damp treatment, not a footing repair. Read salt damp or structural cracking.

What do engineering and approvals add to the cost?

Underpinning usually needs building consent, so the budget should cover the engineer's work, any soil investigation and the consent, on top of the contractor's price. We confirm the approval path with your council or certifier.

  • Diagnosis: our crack and footing report, from $990 + GST ($1,089 inc GST)
  • Second opinion on a quote: from $350 + GST ($385 inc GST), from documents and photos
  • Design and inspections: a fixed quote once the scope is known. See underpinning assessment and design
  • Soil investigation: where the design needs one
  • Building consent: council or an accredited professional, lodged on PlanSA

As a rough guide, published SA price guides list foundation assessment reports at about $600–$1,800 and underpinning design at $1,500–$4,000 (checked November 2026; inclusions vary).

How do you check an underpinning quote before you sign?

Ask what caused the movement, what design the quote is built on and exactly what it includes, then have an independent engineer compare the answers with the house.

  • Has someone other than the contractor diagnosed the cause?
  • Is the work to an engineer's design, based on a soil investigation?
  • How many piers or pins, how deep, and under which walls?
  • Who applies for building consent, and is it in the price?
  • Are leak repairs, drainage, crack repairs and making good included?
  • What happens to the price if stable ground is deeper than assumed?
  • At $20,000 or more, have you received the building indemnity insurance certificate?

Why an independent assessment comes first

Many underpinning and resin injection contractors bring their own engineer. We never sell, recommend a contractor for or carry out repairs, so our independent assessment, from $350 + GST ($385 inc GST), is only about your house. If underpinning isn't needed, our report says so.

When to call a structural engineer

Call an engineer before you call a contractor, and again before you sign anything.

  • Cracks are 5 mm or wider or still growing. Read cracks in walls: when to worry
  • You have an underpinning or resin quote and no independent diagnosis
  • Two quotes differ by thousands for what looks like the same job
  • Your certifier needs an engineer's design or independent certification
  • You're buying a house with signs of movement. See our pre-purchase structural inspection

Sources

  1. Published price ranges from Adelaide underpinning contractors, referral sites and other local businesses. Checked November 2026; GST and inclusions vary
  2. Planning, Development and Infrastructure (General) Regulations 2017 (SA). Schedule 4 clause 4(4) (repairs), reg 64 (neighbour stability)
  3. Legal Services Commission of SA, Law Handbook: neighbour excavation and section 139
  4. SAFA, About building indemnity insurance
  5. PlanSA, Significant and regulated trees
  6. Sheard and Bowman (1996), soils of the Adelaide area, Mines and Energy SA and CSIRO (SARIG document RB9400009)

FAQ

Underpinning cost in Adelaide: FAQs

Still unsure? Call 08 7083 9853 or send photos for a fixed quote.

How much does underpinning cost in Adelaide?

Adelaide contractors and referral sites publish ranges from about $5,000 to $40,000–$50,000, with full replacements quoted at $30,000–$80,000 or more. They are other businesses' published figures. Only a quote for your house, built on a proper diagnosis, is a real price.

Why are underpinning quotes so different from each other?

They often price different jobs: another method, more or fewer piers, a different depth, different inclusions. When an independent engineer diagnoses the cause and designs the repair first, every contractor prices the same scope.

Does underpinning need approval in SA?

Usually it needs building consent. We confirm with your council or certifier for your job. Repairs are exempt only when they don't adversely affect the structural soundness of the building.

Can I avoid underpinning?

Often. If the movement comes from a leak, a downpipe, ponding water or a tree, fixing that and watching the cracks through a full year may be all that's needed. A crack report tells you before you commit to a repair.

Is resin injection cheaper than underpinning?

Sometimes. Published Adelaide figures put resin injection at about $5,000–$15,000 against $20,000–$100,000 or more for underpinning, but the methods suit different ground and causes. Compare them only after the cause is known.

What does an engineer cost on an underpinning job?

Our second opinion on a quote starts from $350 + GST ($385 inc GST) and our crack and footing report from $990 + GST ($1,089 inc GST). Published SA price guides put underpinning design at about $1,500–$4,000. Our design is a fixed quote once the scope is known.

Is undersetting the same as underpinning?

No. Undersetting replaces the base of a damp wall in sections with a new damp-proof course. Underpinning treats cracking from settlement or footing failure. Read salt damp or structural cracking.

Do you sell or carry out underpinning?

No. We are independent engineers: we inspect, diagnose, design and certify, and we never sell, recommend a contractor for or carry out repairs. If underpinning isn't needed, our report says so.